guitar finishing nitro
Removal guitar finish?

How could I go about removing a 3 tone burst of an early Mexican. I want to refinish with a finish white nitro. what kind of finish is on it? I know Mexican strats with solid colors are finished with a polyester lining rediculously thick

You can sand the paint layer and when you get to FullerPlast stop there. Fullerplast soaks into the wood and creates a seal that prevents following coats of immersion in the wood like a sponge. This means spraying the color coats is easier and the coatings can be applied thinner material (savings, money and dry weather). Fullerplast dry in 15 minutes and was then painted on the spot. As for you, you use what you paint and when finished, apply some polyester in light coats to give a glossy finish. Use a good palm sander used available for a reasonable price (about U.S. $ 15-20). This tool alone will give the best results beyond the traditional block of sand. Or, a sponge as a sandpaper fine / medium grain or medium grain ongoing in nature. They allow you not only get the most stubborn areas, but it will also soften the hardest of contrasting contours. When you begin to see the wood, move down to a finer grit sand paper as 100-120 courage to finally shed the last layer of paint. Then complete the move down to 150 or 180 grain just to give the wood a feeling total smoothness. Spray the base with white enamel finish and polyester lining.

Build a Jazz Bass from a Kit

Didnt See What You Are Looking For? - Try Google!
Custom Search